Search results
Results from the WOW.Com Content Network
A 3800 Series II L67 Supercharged V6 engine in a 1998 Buick Regal GS. The L67 is the supercharged version of the 3800 Series II L36 and appeared in 1996, one year after the naturally aspirated version. It uses the Eaton Generation III M90 supercharger with a 3.8 in (97 mm) pulley, a larger throttle body, different fuel injectors, different ...
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
For 1993 to 1995, the V6 was the 3.4 L (208 cu in) 60°; 1996–2002 cars received the 3.8L (231 cu in) 3800 Series II V6. 1993–1997 V8 cars shipped with the 5.7L (350 cu in) LT1, while 1998–2002 cars received the 5.7L (346 cu in) LS1. Both engines were available with the 4L60E four-speed automatic transmission.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
1917–1924 Buick Series 30 OHV 170 cu in (2.8 L) inline-4 [13] 1909 Oakland Model 40 [9] [14] (acquired as part of the founding of GM) 1913–1928 Chevrolet inline-4 (acquired as part of Chevrolet's merger into GM) 1923 Chevrolet Series M Copper-Cooled; 1937–1965 Opel Olympia OHV; 1960–1963 Pontiac Trophy 4 (derived from the Pontiac 389)
The 3800 Series II L67 Supercharged engine in a 1998 GS. 1997–2004 3.8 L L36 Series II V6; 1997–2004 3.8 L L67 Series II supercharged V6; The Regal LS from the factory had a 1/4 mile (≈400 m) elapsed time (ET) of 15.8 seconds and could do 0-60 mph in under 8 seconds.
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.
New serial number codes: GP 1 ⁄ 2 ton, GR 3 ⁄ 4 ton, & GS 1 ton. Late 1949 - Hood side emblems no longer read "Thriftmaster" or "Loadmaster", but are now numbers that designate cargo capacity: 3100 on 1 ⁄ 2 ton, 3600 on 3 ⁄ 4 ton, 3800 on 1 ton. Serial number codes remain the same as on early 1949.