Search results
Results from the WOW.Com Content Network
Keycode is different from scancode, the sequence of data generated when pressing or releasing a key on a computer keyboard, however, in legacy documents it may still refer to scancode. Keycode or may refer to: Keykode, an Eastman Kodak's a bar coding placed at regular intervals on negative films; Keycode, for a lock
There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers. The HTML codes can be used where a literal character would cause confusion, such as using code "[" or "]" to show the left or right square bracket ('[' or ']').
The bitting code is used in conjunction with a key's Depth and Spacing Number to completely determine all relevant information regarding the key's geometry. [1] Each number in the bitting code corresponds to a cut on the key blade. For example, a bitting code of 11111 with Depth and Spacing Number 46 specifies a Kwikset key with five shallow cuts.
The most commonly encountered are the "XT" ("set 1") scancodes, based on the 83-key keyboard used by the IBM PC XT and earlier. These mostly consist of a single byte; the low 7 bits identify the key, and the most significant bit is clear for a key press or set for a key release. Some additional keys have an E0 (or rarely, E1 or E2) prefix.
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use. Important messages could be ...
A Control key (marked "Ctrl") on a Windows keyboard next to one style of a Windows key, followed in turn by an Alt key The rarely used ISO keyboard symbol for "Control". In computing, a Control keyCtrl is a modifier key which, when pressed in conjunction with another key, performs a special operation (for example, Ctrl+C).
Keykode (also written as either KeyKode or KeyCode) is an Eastman Kodak Company advancement on edge numbers, which are letters, numbers and symbols placed at regular intervals along the edge of 35 mm and 16 mm film to allow for frame-by-frame specific identification. It was introduced in 1990.
In other words, it does not matter whether the key would have produced an upper-case or a lower-case letter. The interpretation of the control key with the space, graphics character, and digit keys (ASCII codes 32 to 63) varies between systems. Some will produce the same character code as if the control key were not held down.