Search results
Results from the WOW.Com Content Network
The RL78 was developed to address extremely low power but highly integrated microcontroller applications, to this end the core offered a novel low power mode of operation called “snooze mode” where the ADC or serial interface can be programmed to meet specific conditions to wake the device from the extreme low power STOP mode of 0.52uA.
The Intel 8253 PIT was the original timing device used on IBM PC compatibles.It used a 1.193182 MHz clock signal (one third of the color burst frequency used by NTSC, one twelfth of the system clock crystal oscillator, [1] therefore one quarter of the 4.77 MHz CPU clock) and contains three timers.
An oscillator start-up timer (OST) is a module used by some microcontrollers to keep the device reset until the crystal oscillator is stable. When a crystal oscillator starts up, its frequency is not constant, which causes the clock frequency to be non-constant. This would cause timing errors, leading to many problems.
The 555 timer IC is an integrated circuit used in a variety of timer, delay, pulse generation, and oscillator applications. It is one of the most popular timing ICs due to its flexibility and price. It is one of the most popular timing ICs due to its flexibility and price.
Depending on the application, a microcontroller's GPIOs may comprise its primary interface to external circuitry or they may be just one type of I/O used among several, such as analog signal I/O, counter/timer, and serial communication. In some ICs, particularly microcontrollers, a GPIO pin may be capable of other functions than GPIO.
A digital signal controller (DSC) is a hybrid of microcontrollers and digital signal processors (DSPs). Like microcontrollers, DSCs have fast interrupt responses, offer control-oriented peripherals like PWMs and watchdog timers, and are usually programmed using the C programming language, although they can be programmed using the device's native assembly language.
A watchdog timer (WDT, or simply a watchdog), sometimes called a computer operating properly timer (COP timer), [1] is an electronic or software timer that is used to detect and recover from computer malfunctions. Watchdog timers are widely used in computers to facilitate automatic correction of temporary hardware faults, and to prevent errant ...
The documentation for microcontrollers from past decades would easily be inclusive in a single document, but as chips have evolved so has the documentation grown. The total documentation is especially hard to grasp for all ARM chips since it consists of documents from the IC manufacturer ( Cypress Semiconductor ) and documents from CPU core ...