Search results
Results from the WOW.Com Content Network
For example, pharmaceuticals that pick up more than 5% by mass, between 40 and 90% relative humidity at 25 °C, are described as hygroscopic, while materials that pick up less than 1%, under the same conditions are regarded as non-hygroscopic. [32] The amount of moisture held by hygroscopic materials is usually proportional to the relative ...
Variables on the material points: positions, velocities, strains, stresses etc. are then updated with these rates depending on integration scheme of choice and a suitable constitutive model. Resetting of grid. Now that the material points are fully updated at the next time step, the grid is reset to allow for the next time step to begin.
Section 5.2 of The Building Regulations 2010 Approved Document C, "Site preparation and resistance to contaminants and moisture" [10] requires that buildings should be constructed to resist rising damp, penetrating damp, and condensation. Walls should: resist the passage of moisture from the ground to the inside of the building; and
EN 1992-1-2 deals with the design of concrete structures for the accidental situation of fire exposure and is intended to be used in conjunction with EN 1992-1-1 and EN 1991-1-2. This part 1-2 only identifies differences from, or supplements to, normal temperature design. Part 1-2 of EN 1992 deals only with passive methods of fire protection.
The value of the EMC depends on the material and the relative humidity and temperature of the air with which it is in contact. The speed with which it is approached depends on the properties of the material, the surface-area-to-volume ratio of its shape, and the speed with which humidity is carried away or towards the material (e.g. diffusion ...
The relationship between water content and equilibrium relative humidity of a material can be displayed graphically by a curve, the so-called moisture sorption isotherm. For each humidity value, a sorption isotherm indicates the corresponding water content value at a given temperature. If the composition or quality of the material changes, then ...
In the hygroscopic cycle, the gas absorbed-dissolved into the other fluid is the steam coming from the outlet of the steam turbine. As the steam is absorbed-dissolved into the hygroscopic fluid, more steam can condense, and the reduction in vapor pressure is equivalent to a reduction in the condensation pressure at the outlet of the steam turbine.
Hempcrete is a construction building material that uses hemp shives, aggregate, water, and a type of binder to act as non-bearing walls, insulators, finishing plasters, and blocks. The material has low mechanical properties and low thermal conductivity, making it ideal for insulation material.