Search results
Results from the WOW.Com Content Network
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.
A double switch, or double slip—the points are set to connect the upper left and lower right tracks. A double slip switch (double slip) is a narrow-angled diagonal flat crossing of two lines combined with four pairs of points in such a way as to allow vehicles to change from one straight track to the other, alternatively to going straight ...
A double-switched relay cannot close inadvertently with the application of the same current. At least two separate faults would be required to allow this relay to close inadvertently. Double switching , double cutting , or double breaking is the practice of using a multipole switch to close or open both the positive and negative sides of a DC ...
A switch with both types of contact is called a changeover switch or double-throw switch. These may be "make-before-break" ("MBB" or shorting) which momentarily connects both circuits, or may be "break-before-make" ("BBM" or non-shorting) which interrupts one circuit before closing the other.
Below is a list of typical switch configurations and usage: Single pole, double throw (SPDT or 1:2) switches route signals from one input to two output paths. Single pole double throw (SPDT) switch from Agilent Technologies. Multiport switches or single pole, multiple throw (SPnT) switches allow a single input to multiple (three or more) output ...
In baseball, the double switch is a type of player substitution, usually performed by a team while playing defense. The double switch is typically used to make a pitching substitution, while simultaneously placing the incoming pitcher in a more favorable spot in the batting order than was occupied by the outgoing pitcher.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...