Search results
Results from the WOW.Com Content Network
The Attachment Unit Interface (AUI) is a physical and logical interface defined in the IEEE 802.3 standard for 10BASE5 Ethernet [1] and the earlier DIX standard. The physical interface consists of a 15-pin D-subminiature connector that links an Ethernet node's physical signaling to the Medium Attachment Unit (MAU), [ 2 ] sometimes referred to ...
Reduced Pin eXtended Attachment Unit Interface (RXAUI) is a proprietary modification created by Marvell [2] and Dune Networks [3] (later acquired by Broadcom [4]) aimed to increase the port density by decreasing the interface pin count. The four lanes of the standard XAUI running at 3.125 Gbit/s are replaced by two lanes at 6.25 Gbit/s.
Because of this, Apple's computers, billed as having built-in Ethernet, were expensive to connect to Ethernet, perhaps adding as much as a tenth to the total price of the computer system. Additionally, AAUI held no advantage for any system other than 10BASE2, and thus as 10BASE-T became ubiquitous it became impossible to justify the cost of an ...
A Medium Attachment Unit (MAU) is a transceiver which converts signals on an Ethernet cable to and from Attachment Unit Interface (AUI) signals. On original 10BASE5 (thicknet) Ethernet equipment, the MAU was typically clamped to the Ethernet wire via a vampire tap and connected by a multi-wire cable to the computer via a DA-15 port, which was ...
By 2001, prices for Fast Ethernet cards had fallen to under $50. By 2003, Wi-Fi networking equipment was widely available and affordable. Due to the immense demand for high-speed networking, the low cost of Category 5 cable , and the popularity of 802.11 wireless networks, both 10BASE2 and 10BASE5 have become increasingly obsolete , though ...
The gigabit media-independent interface (GMII) is an interface between the medium access control (MAC) device and the physical layer . The interface operates at speeds up to 1000 Mbit/s , implemented using a data interface clocked at 125 MHz with separate eight-bit data paths for receive and transmit, and is backwards compatible with the MII ...
Ethernet over twisted pair also defines a medium-dependent interface – crossover (MDI-X) interface. Auto–MDI-X ports on newer network interfaces detect if the connection would require a crossover and automatically choose the MDI or MDI-X configuration to complement the other end of the link.
Ethernet II frame, or Ethernet Version 2, [g] or DIX frame is the most common type in use today, as it is often used directly by the Internet Protocol. Novell raw IEEE 802.3 non-standard variation frame; IEEE 802.2 Logical Link Control (LLC) frame; IEEE 802.2 Subnetwork Access Protocol (SNAP) frame