Search results
Results from the WOW.Com Content Network
Both Rotella T4 15W-40 conventional and, Rotella T6 5W-40 and 15w-40 Synthetic both list the JASO MA/MA 2 standard; this information can be found on the bottle adjacent to the SAE/API rating stamp. JASO is an acronym that stands for Japanese Automotive Standards Organization. Note that the 10W-30 conventional oil does not list JASO-MA.
The International Lubricant Standardization and Approval Committee (ILSAC) also has standards for motor oil. Introduced in 2004, GF-4 [27] applies to SAE 0W-20, 5W-20, 0W-30, 5W-30, and 10W-30 viscosity grade oils. In general, ILSAC works with API in creating the newest gasoline oil specification, with ILSAC adding an extra requirement of fuel ...
Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered engines.
A .32 ACP FMJ cartridge, a .32 ACP FMJ cartridge in a blued .303 British supplemental chamber, and a .303 British FMJ cartridge (left to right) A caliber conversion device is a device which can be used to non-permanently alter a firearm to allow it to fire a different cartridge than the one it was originally designed to fire.
Use of the TC-14G canister schedule or the TC-23C chemical cartridge schedule for a given respirator depends on whether "acid gas" is a designated contaminant, which is designated for gas mask canisters only, or if the manufacturer is obligated to list all designated contaminants supported by a given chemical cartridge.
The test cartridge must be inserted into the chamber in such a way that the hole in the test cartridge case lines up with a gas port hole that channels the gas pressure from the cartridge case to the face of the sensor. The measurement accuracy of the pressure measurements with 21st century high-pressure sensors is expected to be ≤ 2%. [7]
Gas-operation is a system of operation used to provide energy to operate locked breech, autoloading firearms. In gas-operation, a portion of high-pressure gas from the cartridge being fired is used to power a mechanism to dispose of the spent case and insert a new cartridge into the chamber.
O ratio is also used to predict barrel life in cartridges of the same caliber, but not of different calibres, since the ratio is an extensive quantity that does not correlate to temperature or pressure (e.g. a .50 cal straight cartridge may have the same overbore as a highly necked down .17 cal cartridge).