Search results
Results from the WOW.Com Content Network
To express the efficiency of a generator or power plant as a percentage, invert the value if dimensionless notation or same unit are used. For example: A heat rate value of 5 gives an efficiency factor of 20%. A heat rate value of 2 kWh/kWh gives an efficiency factor of 50%. A heat rate value of 4 MJ/MJ gives an efficiency factor of 25%.
A wheel power divided by the initial jet power, is the turbine efficiency, η = 4u(V i − u)/V i 2. It is zero for u = 0 and for u = V i . As the equations indicate, when a real Pelton wheel is working close to maximum efficiency, the fluid flows off the wheel with very little residual velocity. [ 11 ]
Pumped storage plants, like other hydroelectric plants, can respond to load changes within seconds. The most important use for pumped storage has traditionally been to balance baseload powerplants, but they may also be used to abate the fluctuating output of intermittent energy sources. Pumped storage provides a load at times of high ...
The first Edison hydroelectric power station, the Vulcan Street Plant, began operating September 30, 1882, in Appleton, Wisconsin, with an output of about 12.5 kilowatts. [16] By 1886 there were 45 hydroelectric power stations in the United States and Canada; and by 1889 there were 200 in the United States alone. [13]
When there is enough flow, power output is limited by plant generating capacity. The maximum power-output curves were calculated based on the average flow rate at the dam site, assuming the water level is 175 m and the plant gross efficiency is 90.15%. The actual power output in 2008 was obtained based on the monthly electricity sent to the grid.
The six-year project would begin in 2013 and extend the plant's life by at least forty years and upgrade the generating capacity from 1,872 megawatts to 2,172 megawatts. [10] Plans for the upgrade include replacing all six of the plant's turbines, which would increase the plant's total generating capacity by 15 percent, and efficiency by 5 percent.
Micro hydro is a type of hydroelectric power that typically produces from 5 kW to 100 kW of electricity using the natural flow of water. Installations below 5 kW are called pico hydro . [ 1 ] These installations can provide power to an isolated home or small community, or are sometimes connected to electric power networks, particularly where ...
Peaking power plants include hydroelectric and gas turbine power plants. Many gas turbine power plants can be fueled with natural gas, fuel oil, and/or diesel , allowing greater flexibility in choice of operation- for example, while most gas turbine plants primarily burn natural gas, a supply of fuel oil and/or diesel is sometimes kept on hand ...