Search results
Results from the WOW.Com Content Network
This standard defines a table structure for utility application data to be passed between an end device and a computer. The "end device" is typically an electricity meter, and the "computer" is typically a hand-held device carried by a meter reader, or a meter communication module which is part of an automatic meter reading system. C12.19 does ...
The meter communicates to its collection point using 900 MHz mesh network topology. Automatic meter reading (AMR) is the technology of automatically collecting consumption, diagnostic, and status data from water meter or energy metering devices (gas, electric) and transferring that data to a central database for billing, troubleshooting, and ...
A typical water meter register showing a meter reading of 8.3 gallons. Notice the black "1" on the odometer has not yet fully turned over, so only the red hand is read. Water meters connected to remote reading devices through three-wire cables. There are several types of registers on water meters.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
An example of a water distribution system: a pumping station, a water tower, water mains, fire hydrants, and service lines [1] [2]. A water distribution system is a part of water supply network with components that carry potable water from a centralized treatment plant or wells to consumers to satisfy residential, commercial, industrial and fire fighting requirements.
In the American version of this test, the table is 10 inches (25 cm) diameter per ASTM C 230. Abrams cone, open at the top and at the bottom - 30 centimetres (12 in) high, 17 centimetres (6.7 in) top diameter, 25 centimetres (9.8 in) base diameter. Water bucket and broom to wet the flow table. Tamping rod, 60 centimetres (24 in) long.
M-Bus or Meter-Bus is a European standard (EN 13757-2 physical and link layer, EN 13757-3 application layer) for the remote reading of water, gas or electricity meters. M-Bus is also usable for other types of consumption meters, such as heating systems or water meters. The M-Bus interface is made for communication on two wires, making it cost ...
Encoder receiver transmitter (ERT) is a packet radio protocol developed by Itron for automatic meter reading. [1] The technology is used to transmit data from utility meters over a short range so a utility vehicle can collect meter data without a worker physically inspecting each meter. The ERT protocol was first described in U.S. patent ...