Search results
Results from the WOW.Com Content Network
A linear encoder is a sensor, transducer or readhead paired with a scale that encodes position. The sensor reads the scale in order to convert the encoded position into an analog or digital signal , which can then be decoded into position by a digital readout (DRO) or motion controller.
The codewords in a linear block code are blocks of symbols that are encoded using more symbols than the original value to be sent. [2] A linear code of length n transmits blocks containing n symbols. For example, the [7,4,3] Hamming code is a linear binary code which represents 4-bit messages using 7-bit codewords. Two distinct codewords differ ...
An encoder is a sensor which turns a position into an electronic signal. There are two forms: Absolute encoders give an absolute position value. Incremental encoders count movement rather than position. With detection of a datum position and the use of a counter, an absolute position may be derived.
This decomposition is useful for the design and analysis of quantization behavior, and it illustrates how the quantized data can be communicated over a communication channel – a source encoder can perform the forward quantization stage and send the index information through a communication channel, and a decoder can perform the reconstruction ...
Latin square based code for non-white noise (prevalent for example in broadband over powerlines) Lexicographic code; Linear Network Coding, a type of erasure correcting code across networks instead of point-to-point links; Long code; Low-density parity-check code, also known as Gallager code, as the archetype for sparse graph codes
Linear block codes have the property of linearity, i.e. the sum of any two codewords is also a code word, and they are applied to the source bits in blocks, hence the name linear block codes. There are block codes that are not linear, but it is difficult to prove that a code is a good one without this property. [4]
The string potentiometer may be connected as a three-wire tapped resistor (voltage divider), in a control circuit, or may be packaged with electronics to produce a measurement signal in a useful form, such as a variable voltage 0-10 VDC, variable current 4-20mA, pulse encoder, Bus (DeviceNet and Canbus) and RS-232 communications.
Rotary incremental encoder with shaft attached to its thru-bore opening Introduction to incremental encoders, from VideoWiki script Incremental Encoder. An incremental encoder is a linear or rotary electromechanical device that has two output signals, A and B, which issue pulses when the device is moved. [1]