Ads
related to: ethernet to usb cable adapter for cell phone booster for truck seats
Search results
Results from the WOW.Com Content Network
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.
Adapters and cables with a USB-C receptacle are not allowed. [33] A Full-Featured USB cable is a Type‑C-to-Type‑C cable that supports USB 2.0, USB 3.2 and USB4 data operation, and a Full-Featured Type‑C receptacle likewise supports the same full set of protocols. [34]
The original USB OTG standard introduced a plug receptacle called mini-AB that was replaced by micro-AB in later revisions (Revision 1.4 onwards). It can accept either a mini-A plug or a mini-B plug, while mini-A adapters allows connection to standard-A USB cables coming from peripherals.
A common EPS must include a cable with a micro USB-B (2.0) connector for connecting to a mobile phone. This cable can be either captive (permanently attached to the power supply) or detachable. If detachable, the cable must connect to the power supply via a standard USB type-A plug. [12]
A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.
A jumper cable connected to the positive (red) terminal. Jumper cables, also known as booster cables or jump leads, are a pair of insulated wires of sufficient capacity with alligator clips at each end to interconnect the disabled vehicle with an auxiliary source, such as another vehicle with the same system voltage or to another battery. The ...
Ads
related to: ethernet to usb cable adapter for cell phone booster for truck seats