Search results
Results from the WOW.Com Content Network
Direction shown by smoke drift but not by wind vanes 2 Light breeze 4–6 knots 4–7 mph 6–11 km/h 1.6–3.3 m/s 1–2 ft 0.3–0.6 m Small wavelets still short but more pronounced; crests have a glassy appearance but do not break Wind felt on face; leaves rustle; wind vane moved by wind 3 Gentle breeze 7–10 knots 8–12 mph 12–19 km/h
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
The old scale lists an F5 tornado as wind speeds of 261–318 mph (420–512 km/h), while the new scale lists an EF5 as a tornado with winds above 200 mph (322 km/h), found to be sufficient to cause the damage previously ascribed to the F5 range of wind speeds.
Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...
As stalling is due to wing loading and maximum lift coefficient at a given altitude and speed, this limits the turning radius due to maximum load factor. At Mach 0.85 and 0.7 lift coefficient, a wing loading of 50 lb/sq ft (240 kg/m 2 ) can reach a structural limit of 7.33 g up to 15,000 feet (4,600 m) and then decreases to 2.3 g at 40,000 feet ...
The combination of a sailing craft's speed and direction with respect to the wind, together with wind strength, generate an apparent wind velocity. When the craft is aligned in a direction where the sail can be adjusted to align with its leading edge parallel to the apparent wind, the sail acts as an airfoil to generate lift in a direction ...
Generally, the supplier of the barrel or dies will also provide the buyer with basic reloading data, giving a variety of powders, charge weights, and bullet weights that can be used for developing loads. Handloaders use the data to develop a load by starting with minimum loads and carefully working up. [citation needed]
A V-n diagram showing V S (stall speed at 1G), V C (corner/maneuver speed) and V D (dive speed) A chart of velocity versus load factor (or V-n diagram) is another way of showing limits of aircraft performance. It shows how much load factor can be safely achieved at different airspeeds. [3]