Search results
Results from the WOW.Com Content Network
For example, consider a 700c × 23 mm tire, which has a nominal cross-section of 23 mm. 700c wheels have a rim diameter of 622 mm. Hence the wheel diameter is (2 × 23 mm) + 622 mm = 668 mm which is equal to 26.3 inches (rounded to 1 decimal place). 26 inch mountain bicycle wheels have a rim diameter of 559 mm. This ignores factors that ...
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
Note how in the below sorted table the "inches" measure is inconsistent with the mm measures, if height varies: Some 28-inch tires then have fewer mm than a 27-inch tire. 584 mm tires are also marketed as 27.5-inch (outer diameter) tires.
Some bicycle wheels are labeled in metric as "700c" for a nominal 700 mm diameter road bike tire, but mountain bike wheels are still often sold in inches (26, 27.5, or 29 inches). [ citation needed ] Common swimming pool dimensions are 25-yard, 25-meter, and 50-meter.
Length; system unit code (other) symbol or abbrev. notes conversion factor/m combinations SI: gigametre: Gm Gm US spelling: gigameter 1.0 Gm (620,000 mi) megametre: Mm Mm US spelling: megameter
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
For most applications, the difference between the two definitions is insignificant – one international foot is exactly 0.999 998 of a US survey foot, for a difference of about 1 ⁄ 8 in (3 mm) per mile – but it affects the definition of the State Plane Coordinate Systems (SPCSs), which can stretch over hundreds of miles.
Before the establishment of the decimal metric system in France during the French Revolution in the late 18th century, [4] many units of length were based on parts of the human body. [5] [6] The Nippur cubit was one of the oldest known units of length. The oldest known metal standard for length corresponds to this Sumerian unit and dates from ...