Search results
Results from the WOW.Com Content Network
Adjusting is the final setting of balancing devices such as dampers and valves, adjusting fan speeds and pump impeller sizes, in addition to automatic control devices such as thermostats and pressure controllers to achieve maximum specified system performance and efficiency during normal operation.
The depth from which a hand pump will suck is limited by atmospheric pressure to an operating depth of less than 7 meters. [5] The height to which a hand pump will lift is governed by the ability of the pump and the operator to lift the weight in the delivery pipe.
Once inlet pressure is introduced, the open poppet allows flow to the diaphragm and pressure in the upper chamber increases, until the diaphragm is pushed upward against the spring, causing the poppet to reduce flow, finally stopping further increase of pressure. By adjusting the top screw, the downward pressure on the diaphragm can be ...
The Pressure Equipment Directive (PED) 2014/68/EU (formerly 97/23/EC) [1] of the EU sets out the standards for the design and fabrication of pressure equipment ("pressure equipment" means steam boilers, pressure vessels, piping, safety valves and other components and assemblies subject to pressure loading) generally over one liter in volume and having a maximum pressure more than 0.5 bar gauge.
A tire-pressure monitoring system (TPMS) monitors the air pressure inside the pneumatic tires on vehicles. [1] A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS).
Some pumps have a gauge that shows the pressure of air that is forced into the tire. Once the tire is at the correct pressure, the pump valve can be removed from the tire, and the cap can be replaced on the tire valve. There are two main types of tire valves to which the bicycle tire pump attaches. These are the Presta valve and the Schrader ...
IEC 60192 Low-pressure sodium vapour lamps – Performance specifications; IEC 60193 Hydraulic turbines, storage pumps and pump-turbines – Model acceptance tests; IEC 60194 Printed board design, manufacture and assembly – Terms and definitions; IEC 60195 Method of measurement of current noise generated in fixed resistors
A roughing pump is any vacuum pump (typically mechanical) used to initially evacuate a vacuum system, as a first stage towards achieving high vacuum or ultra high vacuum. The term "roughing pump" derives from the vacuum range it works in, "rough vacuum", above 1x10 −3 torr (0.1 Pa ).