Search results
Results from the WOW.Com Content Network
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address and Default Gateway address.
On Windows XP, the server, by default, gets the IP address 192.168.0.1. (This default can be changed within the interface settings of the network adapter or in the Windows Registry.) It provides NAT services to the entire 192.168.0.x subnet, even if the address on the client was set manually, not by the DHCP server. Since Windows 7, the 192.168 ...
Private network Used for local communications within a private network [3] 198.18.0.0/15 198.18.0.0–198.19.255.255 131 072: Private network Used for benchmark testing of inter-network communications between two separate subnets [9] 198.51.100.0/24 198.51.100.0–198.51.100.255 256: Documentation Assigned as TEST-NET-2, documentation and ...
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software.
To route IP traffic destined for the network 10.10.20.0/24 via the next-hop router with the IPv4 address of 192.168.100.1, the following configuration commands or steps can be used: Linux [ edit ]
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.