Search results
Results from the WOW.Com Content Network
When talking about circuit bit rates, people will interchangeably use the terms throughput, bandwidth and speed, and refer to a circuit as being a '64 k' circuit, or a '2 meg' circuit — meaning 64 kbit/s or 2 Mbit/s (see also the List of connection bandwidths). However, a '64 k' circuit will not transmit a '64 k' file in one second.
Current (local, "this") network [1] 10.0.0.0/8 10.0.0.0–10.255.255.255 16 777 216: Private network Used for local communications within a private network [3] 100.64.0.0/10 100.64.0.0–100.127.255.255 4 194 304: Private network Shared address space [4] for communications between a service provider and its subscribers when using a carrier ...
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
Router addresses can be superimposed upon maps of their physical locations. This example shows a request from New Zealand to an IP address in Massachusetts which takes a route that passes through Europe. Most implementations include options to specify the number of queries to send per hop, time to wait for a response, the hop limit and port to use.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes. If a router ...
To route IP traffic destined for the network 10.10.20.0/24 via the next-hop router with the IPv4 address of 192.168.100.1, the following configuration commands or steps can be used: Linux [ edit ]
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).