Search results
Results from the WOW.Com Content Network
In the case of a twisted line the individual conductors of an electric circuit swap places, either in their whole course (at cables) or at certain points (at overhead lines). The mutual influence of electrical conductors is reduced by transposing. The unbalance of the line, which can lead to one-sided loads in three-phase systems, is also ...
Twisted-pair cabling was invented by Alexander Graham Bell in 1881. [4] By 1900, the entire American telephone network was either twisted pair or open wire with transposition to guard against interference. Today, most of the twisted pairs in the world are outdoor landlines, owned and maintained by telephone companies, used for voice service.
R and L are elements in series with the line (because they are properties of the conductor) and C and G are elements shunting the line (because they are properties of the dielectric material between the conductors). G represents leakage current through the dielectric and in most cables is very small. The word loop is used to emphasise that the ...
In electrical engineering, a common-mode signal is the identical component of voltage present at both input terminals of an electrical device. In telecommunication, the common-mode signal on a transmission line is also known as longitudinal voltage. Common-mode interference (CMI) is a type of common-mode signal. Common-mode interference is ...
Twisted pair cabling is a type of wiring in which two conductors of a single circuit are twisted together for the purposes of improving electromagnetic compatibility. Compared to a single conductor or an untwisted balanced pair , a twisted pair reduces electromagnetic radiation from the pair and crosstalk between neighboring pairs and improves ...
Twinaxial cabling, or twinax, is a type of cable similar to coaxial cable, but with two inner conductors in a twisted pair instead of one. [3] Due to cost efficiency it is becoming common in modern (2013) very-short-range high-speed differential signaling applications.
The technique sends the same electrical signal as a differential pair of signals, each in its own conductor. The pair of conductors can be wires in a twisted-pair or ribbon cable or traces on a printed circuit board. Electrically, the two conductors carry voltage signals which are equal in magnitude, but of opposite polarity. The receiving ...
Structured cabling consists of six subsystems: [2] Entrance facilities is the point where the telephone company network ends and connects with the on-premises wiring belonging to the customer. Equipment rooms house equipment and wiring consolidation points that serve the users inside the building or campus.