Search results
Results from the WOW.Com Content Network
The RJ45S jack is rarely used in telephone applications, and the keyed 8P8C modular plug used for RJ45S mechanically cannot be inserted into an Ethernet port, but a similar plug, the non-keyed 8P8C modular plug – never used for RJ45S – is used in Ethernet networks, and the connector is often, however improperly, referred to as RJ45 in this ...
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [9] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8/U Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.
The connector provides power to the keyboard on the outer two contacts and receives data signals on the inner pair. The cable between the computer and the keyboard is a coiled cord with an appearance very similar to a telephone handset cable. [11] The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset.
Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.
Cable types, connector types and cabling topologies are defined by ANSI/TIA-568. Category 5 cable is nearly always terminated with 8P8C modular connectors (often referred to incorrectly as RJ45 connectors [14] [15] [16]). The cable is terminated in either the T568A scheme or the T568B scheme. The two schemes work equally well and may be mixed ...
For 10BASE5, connection to the coaxial cable was made with either a vampire tap or a pair of N connectors. For 10BASE2, the connection to the coaxial cable was typically made with a single BNC connector to which a T-piece was attached. For twisted-pair cabling 8P8C, modular connectors are used (often called RJ45 in this context).
These cables typically have four pairs of wires for each connection, although early Ethernet used only two of the pairs. Unlike the earlier -T standards, the -T1 interfaces were designed to operate over a single pair of conductors and introduce the use of two new connectors referred to as IEC 63171-1 [ 5 ] and IEC 63171-6.