Search results
Results from the WOW.Com Content Network
Glitch power comes under dynamic dissipation in the circuit and is directly proportional to switching activity. Glitch power dissipation is 20%–70% of total power dissipation and hence glitching should be eliminated for low power design. Switching activity occurs due to signal transitions which are of two types: functional transition and a ...
A LAG is a method of inverse multiplexing over multiple Ethernet links, thereby increasing bandwidth and providing redundancy. It is defined by the IEEE 802.1AX-2008 standard, which states, "Link Aggregation allows one or more links to be aggregated together to form a Link Aggregation Group, such that a MAC client can treat the Link Aggregation Group as if it were a single link."
MikroTik (officially SIA "Mikrotīkls") is a Latvian network equipment manufacturing company. MikroTik develops and sells wired and wireless network routers, network switches, access points, as well as operating systems and auxiliary software. The company was founded in 1996, and as of 2022, it was reported that the company employed 351 employees.
Modular switches also support additional line cards which can provide new functions to the switch that would previously have been unavailable, such as a firewall. [4] An example of a modular computer network switch is the Cisco Catalyst 6500 , which can be configured with up to 13 slots, and supports connections from RJ45 to QSFP+.
The most common example of the correct use of a switch within a loop is an inversion of control such as an event handler. In event handler loops, the sequence of events is not known at compile-time, so the repeated switch is both necessary and correct (see event-driven programming , event loop and event-driven finite state machine ).
A successful ARP spoofing (poisoning) attack allows an attacker to alter routing on a network, effectively allowing for a man-in-the-middle attack.. In computer networking, ARP spoofing (also ARP cache poisoning or ARP poison routing) is a technique by which an attacker sends Address Resolution Protocol (ARP) messages onto a local area network.
Layer-2 switching is hardware-based, which means switches use ASICs to build and maintain the forwarding information base and to perform packet forwarding at wire speed. One way to think of a layer-2 switch is as a multiport bridge. Layer-2 switching is highly efficient because there is no modification to the frame required.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...