Search results
Results from the WOW.Com Content Network
A 0.5 McFarland standard is prepared by mixing 0.05 mL of 1.175% barium chloride dihydrate (BaCl 2 •2H 2 O), with 9.95 mL of 1% sulfuric acid (H 2 SO 4). [ 1 ] Now there are McFarland standards prepared from suspensions of latex particles, which lengthens the shelf life and stability of the suspensions.
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution. Similarly, for a ...
The agriculture industry uses 500 tons per year as a fertilizer. In particular, its use has been suggested for treatment of whiptail in broccoli and cauliflower in molybdenum-deficient soils. [4] [5] However, care must be taken because at a level of 0.3 ppm sodium molybdate can cause copper deficiencies in animals, particularly cattle. [3]
In chemistry, acid value (AV, acid number, neutralization number or acidity) is a number used to quantify the acidity of a given chemical substance.It is the quantity of base (usually potassium hydroxide (KOH)), expressed as milligrams of KOH required to neutralize the acidic constituents in 1 gram of a sample.
The main difference between solution (1) and solution (2) is the different use of nitrate-nitrogen and ammonium-nitrogen based stock solutions to prepare the respective Hoagland solution of interest. Accordingly, the original 1933 and the modified concentrations of 1938 and 1950 for each essential element and sodium are shown below, the ...
The IMO regulation is mostly used and sets salt levels to a maximum of 50 mg/m 2 soluble salts measured as sodium chloride. These measurements are done by means of a Bresle test . Salinization (increasing salinity, aka freshwater salinization syndrome ) and subsequent increased metal leaching is an ongoing problem throughout North America and ...
In the case of citric acid, the overlap is extensive and solutions of citric acid are buffered over the whole range of pH 2.5 to 7.5. Calculation of the pH with a polyprotic acid requires a speciation calculation to be performed. In the case of citric acid, this entails the solution of the two equations of mass balance:
Copper(II) oxide reacts with mineral acids such as hydrochloric acid, sulfuric acid, and nitric acid to give the corresponding hydrated copper(II) salts: [4] CuO + 2 HNO 3 → Cu(NO 3) 2 + H 2 O CuO + 2 HCl → CuCl 2 + H 2 O CuO + H 2 SO 4 → CuSO 4 + H 2 O. In presence of water it reacts with concentrated alkali to form the corresponding ...