Search results
Results from the WOW.Com Content Network
The Haeco-CSG process was designed to make stereophonic vinyl LP records compatible with mono playback equipment. These recordings were intended to make the two-channel stereo mix automatically "fold-down" properly to a single mono channel.
Byte 1: indicates if the audio stream is stereo, mono or some other combination. bits 0–3: Indicates the relationship of the two channels; they might be unrelated audio data, a stereo pair, duplicated mono data, music and voice commentary, a stereo sum/difference code. bits 4–7: Used to indicate the format of the user channel word
Audio source category indicating the type of source equipment (general, CD-DA, DVD, etc.) 7 L-bit, original or copy [A] 2 0–3 Source number 4–7 Channel number 3 0–3 Sampling frequency: 0000 2: 44.1 kHz, 0100 2: 48 kHz, 1100 2: 32 kHz 4–5 Clock accuracy: 10 2: 50ppm, 00 2: 1100ppm, 01 2: variable pitch (requires compatible receiver) 6–7
Although mini-DIN connectors are used for S-Video connections, composite video, component video, and analog audio (mono or stereo) all use RCA connectors unless the signals are sent via SCART. In the digital realm, however, combined A/V connectors are gaining ground: HDMI is commonly used today for consumer electronics; and DisplayPort , a ...
A diagram of monaural sound. Monaural sound or monophonic sound (often shortened to mono) is sound intended to be heard as if it were emanating from one position. [1] This contrasts with stereophonic sound or stereo, which uses two separate audio channels to reproduce sound from two microphones on the right and left side, which is reproduced with two separate loudspeakers to give a sense of ...
A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.
Photo: 2.5 mm mono (TS), 3.5 mm mono and stereo (TRS), and 1 ⁄ 4 inch (6.4 mm) stereo (TRS) phone connectors The most common microphone connector in consumer use is the venerable phone connector, in 1 ⁄ 4 inch (6.4 mm), 3.5 mm, and 2.5 mm sizes, and in both mono and stereo configurations.
Mono equipment receiving stereo output will simply use the left (tip) channel as the mono input signal and lose the right (ring) channel of the stereo audio. The positive (tip) component of a balanced signal will be received, though without the full benefits of balanced audio, since the signal's negative (ring) component will be lost.