Search results
Results from the WOW.Com Content Network
Gypsum waste from new construction activities is typically a clean waste, and primarily consists of off-cuts of plasterboard (drywall, wallboard or gyprock) when the boards have been cut to fit the dimensions of the wall or ceiling. The waste may constitute 15% of the gypsum materials used on the site.
Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate , with or without additives, typically extruded between thick sheets of facer and backer paper, used in the construction ...
In North America, troweling joint mud on gypsum panels is a standard construction technique prior to painting wall and ceiling surfaces. Joint compound type and formula selection forms part of a drywall system that can be finished anywhere from a level 0 to a level 5, where 0 is not finished in any fashion, and 5 is the most pristine. [2]
Midland was also the site of a large plant that produced wallboard and plasterboard. For some time, there was a three part railroad between the quarry and the crusher, the last part being a 3 ft (914 mm) narrow gauge line running few miles. [1] The town's water was shipped from Blythe by rail. [2]
Plaster City, California is a company town with a large gypsum quarry and plant owned by United States Gypsum (USG) [1] in Imperial County, California. It is located 17 miles (27 km) west of El Centro , [ 1 ] at an elevation of 105 feet (32 m), a two-hour drive south of Palm Springs , or a 90 minute drive east from San Diego .
Knauf Group is a multinational, family-owned company based in Iphofen, Germany, well known for drywall gypsum boards, founded in 1932. The company is a producer of building materials and construction systems comprising construction materials for drywall construction, plasterboard, cement boards, mineral fibre acoustic boards, dry mortars with gypsum for internal plaster and cement-based ...
This type of joint can be made with a V-shaped jointer or a trowel soon after the bricks are laid. Ornamental and highly visible, the joint conceals small irregularities and is highly attractive. Like the concave joint, the V-joint is water-resistant because its formation compacts the mortar and its shape directs water away from the seal.
Lath and plaster largely fell out of favour in the U.K. after the introduction of plasterboard in the 1930s. [2] In Canada and the United States, wood lath and plaster remained in use until the process was replaced by transitional methods followed by drywall (the North American term for plasterboard) in the mid-twentieth century. [citation needed]