Search results
Results from the WOW.Com Content Network
For ALDL connections, pin 9 is the data stream, pins 4 and 5 are ground, and pin 16 is the battery voltage. An OBD 1.5 compatible scan tool is required to read codes generated by OBD 1.5. Additional vehicle-specific diagnostic and control circuits are also available on this connector.
English: OBD-II type B female connector shape and pinout (The pins inside the connector are female, while the connector itself —the plastic body— is male). Español: Aspecto y posición de los contactos en un conector OBD-II hembra (los contactos son hembra, pero el cuerpo del conector es macho).
pin 2: CAN-Low (CAN−) pin 3: GND (ground) pin 7: CAN-High (CAN+) pin 9: CAN V+ (power) A male DE-9 connector (plug) This de facto mechanical standard for CAN could be implemented with the node having both male and female 9-pin D-sub connectors electrically wired to each other in parallel within the node. Bus power is fed to a node's male ...
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo. Other European brands have usually used KWP. The pinout for the 9-pin connector is:
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Unfortunately, the definition of which signals were present on each pin varied between vehicle models. There were generally only three pins used for basic ALDL —ground, battery voltage, and a single line for data—, although other pins were often used for additional vehicle-specific diagnostic information and control interfaces.
English: OBD-II type A female connector shape and pinout (The pins inside the connector are female, while the connector itself —the plastic body— is male). Español: Aspecto y posición de los contactos en un conector OBD-II hembra (los contactos son hembra, pero el cuerpo del conector es macho).