Search results
Results from the WOW.Com Content Network
The HP-16C Computer Scientist is a programmable pocket calculator that was produced by Hewlett-Packard between 1982 and 1989. It was specifically designed for use by computer programmers, to assist in debugging. It is a member of the HP Voyager series of programmable calculators. It was the only programmer's calculator ever produced by HP ...
In computing, a memory module or RAM stick is a printed circuit board on which memory integrated circuits are mounted. [ 1 ] Memory modules permit easy installation and replacement in electronic systems, especially computers such as personal computers , workstations , and servers .
A test with DDR and DDR2 RAM in 2005 found that average power consumption appeared to be of the order of 1–3 W per 512 MB module; this increases with clock rate and when in use rather than idling. [14] A manufacturer has produced calculators to estimate the power used by various types of RAM. [15]
Memory modules added RAM main memory to the calculator, allowing more programming steps and/or more data registers. The original HP-41C had a main memory of 63 registers of 7 bytes each. Each register could hold either a number, a 6-character string, or up to seven program steps in the FOCAL language (program steps used a variable number of bytes).
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
Double Data Rate 2 Synchronous Dynamic Random-Access Memory (DDR2 SDRAM) is a double data rate (DDR) synchronous dynamic random-access memory (SDRAM) interface.It is a JEDEC standard (JESD79-2); first published in September 2003. [2]
(For example, if a computer has 2 GB (1024 3 B) of RAM and a 1 GB page file, the operating system has 3 GB total memory available to it.) When the system runs low on physical memory, it can " swap " portions of RAM to the paging file to make room for new data, as well as to read previously swapped information back into RAM.
Computational RAM (C-RAM) is random-access memory with processing elements integrated on the same chip. This enables C-RAM to be used as a SIMD computer. It also can be used to more efficiently use memory bandwidth within a memory chip. The general technique of doing computations in memory is called Processing-In-Memory (PIM).