Search results
Results from the WOW.Com Content Network
One end is pierced for the string; the other is squared off to fit in a tuning lever socket. The middle section, which would pass through the wood, is tapered. A variety of methods are used to tune different stringed instruments. Most change the pitch produced when the string is played by adjusting the tension of the strings.
Winders have a center roll (a bobbin, spool, reel, belt-winding shell, etc.) on which the material is wound up. Often there are metal bars that travel through the center of the roll and are shaped according to their intended purpose. A circular bar facilitates greater speed, while a square bar provides a greater potential for torque.
The characteristics of a turned chair are that the frame members are turned cylindrical on a lathe. The main uprights are usually heavier and plainly turned, the lighter spindles infilling between them are more decoratively turned, often with repeated bobbin turning, so as to appear as a series of balls, beads or bails. The complexity of this ...
The intervals for the blocks are specified in the building code or as calculated by a structural engineer. Blocking also resists the rotational movement, or twisting, of floor joists as they deflect under load. This may take the form of diagonal cross bracing, or herringbone, bracing between floor joists.
A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.
Overhead electrical wires may be kept in tension by springs or weights. Conveyor belts; Chair lift and gondola lift cables; Certain wood trusses, such as the beam tensioner truss picture below. [5] [6] Fencing made of wire, such as electric fences, barbed-wire fences, and chainlink fences often include tensioning devices to keep them taut.
In most angiosperms reaction wood is called tension wood. Tension wood forms on the side of the part of the plant that is under tension, pulling it towards the affecting force (upwards, in the case of a branch). It has a higher proportion of cellulose than normal wood. Tension wood may have as high as 60% cellulose. [3] In gymnosperms and ...
The first nine blocks in the solution to the single-wide block-stacking problem with the overhangs indicated. In statics, the block-stacking problem (sometimes known as The Leaning Tower of Lire (Johnson 1955), also the book-stacking problem, or a number of other similar terms) is a puzzle concerning the stacking of blocks at the edge of a table.