Search results
Results from the WOW.Com Content Network
The across-flats definition is the common standard today, and has been for many decades. The larger spanner in this photo is from the 1920s or earlier. Its face was polished to allow the size stamp to show well in the photograph. This example is American, but it illustrates the way that spanners for Whitworth fasteners were typically labelled.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
Unified Coarse/Fine diameters and tap drill sizes (U.S. units) Unified Coarse/Fine tap drill sizes (U.S. units) Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size ...
] BSF threads use the 55 degree Whitworth thread form. It was introduced by the British Engineering Standards Association in 1908. [2] The table provides BSF sizes, the threads per inch and spanner jaw sizes. The BSC column indicates where BSF and BSC threads match. The table shows suitable tapping drill sizes. Uncommon sizes are shown in italics.
Below are some common spanner sizes for metric screw threads. Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have ...
British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.
Whitworth pipe threads 1/4"-6" Thread diameter, sizes, teaching information: Withdrawn: DIN 13-1: ISO general purpose metric screw threads – Part 1: Nominal sizes for coarse pitch threads; nominal diameter from 1 mm to 68 mm: Active: DIN 13-2
The thread angle is different from that used by Whitworth (55°), US Unified threads (60°) and ISO Metric (60°) so BA fasteners are not properly interchangeable with Whitworth or metric ones even when the pitch and diameter are similar enough that they can be screwed together (e.g., although 0BA appears similar to M6×1mm, the male and female ...