enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Metric drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).

  3. Help:Convert - Wikipedia

    en.wikipedia.org/wiki/Help:Convert

    By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.

  4. Help:Convert units - Wikipedia

    en.wikipedia.org/wiki/Help:Convert_units

    When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.

  5. Conversion of units - Wikipedia

    en.wikipedia.org/wiki/Conversion_of_units

    Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.

  6. Inch - Wikipedia

    en.wikipedia.org/wiki/Inch

    Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

  7. Template:Convert - Wikipedia

    en.wikipedia.org/wiki/Template:Convert

    Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...

  8. List of unusual units of measurement - Wikipedia

    en.wikipedia.org/wiki/List_of_unusual_units_of...

    A metric ounce is an approximation of the imperial ounce, US dry ounce, or US fluid ounce. These three customary units vary. However, the metric ounce is usually taken as 25 or 30 ml (0.88 or 1.06 imp fl oz; 0.85 or 1.01 US fl oz) when volume is being measured, or in grams when mass is being measured.

  9. File:Mm to 1 inch fraction ruler.svg - Wikipedia

    en.wikipedia.org/wiki/File:Mm_to_1_inch_fraction...

    English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.