Ads
related to: boiler pilot light won't ignite switch for 30
Search results
Results from the WOW.Com Content Network
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
Start your fireplace without the hassle by learning more about the pilot light, including how to start it and warning signs to watch for.
Gas stoves today use two basic types of ignition sources, standing pilot and electric. [21] A stove with a standing pilot has a small, continuously burning gas flame (called a pilot light) under the cooktop. [21] The flame is between the front and back burners. When the stove is turned on, this flame lights the gas flowing out of the burners.
A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.
A piezo igniter element from a typical lighter. Piezo ignition is a type of ignition that is used in portable camping stoves, gas grills and some lighters. [1] Piezo ignition uses the principle of piezoelectricity, which is the electric charge that accumulates in some materials in response to mechanical deformation.
Auto reignition is a process used in gas burners to control ignition devices based on whether a burner flame is lit. This information can be used to stop an ignition device from sparking, which is no longer necessary after the flame is lit.
An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...
As illustrated in the use of the thermostat above, all of the power for the control system is provided by a thermopile which is a combination of many stacked thermocouples, heated by the pilot light. The thermopile produces sufficient electrical power to drive a low-power gas valve, which under control of one or more thermostat switches, in ...
Ads
related to: boiler pilot light won't ignite switch for 30