Search results
Results from the WOW.Com Content Network
A double-action trigger, also known as double-action only (DAO) to prevent confusion with the more common hybrid DA/SA designs, is a trigger that must perform the double function of both cocking and releasing the hammer/striker. Such trigger design either has no internal sear mechanism capable of holding the hammer/striker in a still position ...
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
CafePress, Inc. was founded as a privately owned company in 1999 by Fred Durham and Maheesh Jain. [2] [3]In July 2008, CafePress acquired the specialist photographic art printing business Imagekind, [4] and in September 2010 further acquired photo-to-canvas company Canvas On Demand to add to their platform of brands.
The preinstalled trigger of a particular firearm is replaced by the forced reset trigger's assembly. Typically, only one shot is fired per single function of the trigger. However, in the U.S., the ATF considers some forced reset triggers to be machineguns under the National Firearms Act . [ 1 ]
From the top: striker-fired, linear hammer with free-floating firing pin, hammer-fired with free-floating firing pin, and hammer-fired with integral firing pin. A firing pin or striker is a part of the firing mechanism of a firearm that impacts the primer in the base of a cartridge and causes it to fire.
The VP9 trigger has a short, light take-up with a solid, single action type break followed by a short positive reset. The average weight of the stock trigger pull is 5.2 lb f (23 N). The VP9 trigger has a consistent pre-travel pull followed by a positive set with clean break. Disassembly does not involve releasing the striker by squeezing the ...
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.