Search results
Results from the WOW.Com Content Network
The derivation of the maximum arching moment of resistance of laterally restrained concrete bridge deck slabs utilised Rankin's [21] idealised elastic-plastic stress-strain criterion for concrete, valid for concrete cylinder strengths up to at least 70N/mm 2, which he had derived on the basis of Hognestad, Hanson and McHenry's [23] ultimate ...
An unreinforced masonry building (or UMB, URM building) is a type of building where load bearing walls, non-load bearing walls or other structures, such as chimneys, are made of brick, cinderblock, tiles, adobe or other masonry material that is not braced by reinforcing material, such as rebar in a concrete or cinderblock. [1]
The California Bearing Ratio (CBR) is a measure of the strength of the subgrade of a road or other paved area, and of the materials used in its construction. The ratio is measured using a standardized penetration test first developed by the California Division of Highways for highway engineering . [ 1 ]
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
Detonating cord is also employed directly in building demolition where thin concrete slabs need be broken via channels drilled parallel to the surface, an advantage over dynamite since a lower minimum of explosive force may be used and smaller diameter holes are sufficient to contain the explosive. [2]
Slab-on-grade or floating slab foundations are a structural engineering practice whereby the concrete slab that is to serve as the foundation for the structure is formed from a mold set into the ground. The concrete is then placed into the mold, leaving no space between the ground and the structure.
Special wall fasteners (screw wall plug anchors) designed for autoclaved aerated concrete including gypsum board and plaster tiles are available at a higher cost than standard expandable wall plugs, including special safety-relevant anchors for high load bearing; [59] [60] [61] It is recommended that fixing holes be drilled using HSS drill bits ...