Search results
Results from the WOW.Com Content Network
For a given material, conductors with a larger cross-sectional area have less resistance than conductors with a smaller cross-sectional area. For bare conductors, the ultimate limit is the point at which power lost to resistance causes the conductor to melt. Aside from fuses, most conductors in the real world are operated far below this limit ...
Substances in which electricity can flow are called conductors. A piece of conducting material of a particular resistance meant for use in a circuit is called a resistor. Conductors are made of high-conductivity materials such as metals, in particular copper and aluminium. Resistors, on the other hand, are made of a wide variety of materials ...
Electrical resistivity (also called volume resistivity or specific electrical resistance) is a fundamental specific property of a material that measures its electrical resistance or how strongly it resists electric current. A low resistivity indicates a material that readily allows electric current.
Copper is the preferred conductor material for underground transmission lines operating at high and extra-high voltages to 400 kV. The predominance of copper underground systems stems from its higher volumetric electrical and thermal conductivities compared to other conductors.
In practice, most organic conductors are doped oxidatively to give p-type materials. The redox doping of organic conductors is analogous to the doping of silicon semiconductors, whereby a small fraction of silicon atoms are replaced by electron-rich, e.g. , phosphorus , or electron-poor, e.g. , boron , atoms to create n-type and p-type ...
This material which must have started out like unfired pottery was slip cast from fused silica. Then it was dried four days at 333 K before being tested. It was 9 inches in diameter and 1 inch thick, density 1.78 ⋅ cm −3. The first run went to 1317K and then on the second run the same insulator proved to be more conductive. 1959. [110 ...
Electrical cable diagram Flexible mains cable with three 2.5 mm solid copper conductors. An electrical cable is an assembly of one or more wires running side by side or bundled, which is used as an electrical conductor to carry electric current.
A semiconductor is a material that is between the conductor and insulator in ability to conduct electrical current. [1] In many cases their conducting properties may be altered in useful ways by introducing impurities ("doping") into the crystal structure.