Search results
Results from the WOW.Com Content Network
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
The original tool supported cutter sizes from 4 mm to 10 mm with available tenon sizes from 4x20 mm up to 10x50 mm. This allowed joints in stock as thin as 10 millimetres (0.39 in). Later a bigger tool was introduced allowing tenon sizes up to 14x140 mm, opening many carpentry use cases for the tool family.
Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]
A slim jim (more technically known as a lockout tool) is a thin strip of metal (usually spring steel) roughly 60 centimetres (24 in) long and about 2–4 centimetres (0.79–1.57 in) wide originally marketed under that name by HPC Inc., a manufacturer and supplier of specialty locksmithing tools.
This is an accepted version of this page This is the latest accepted revision, reviewed on 21 January 2025. Device to open or close door Various examples of door handles throughout history A door handle or doorknob is a handle used to open or close a door. Door handles can be found on all types of doors including: exterior doors of residential and commercial buildings, internal doors, cupboard ...
The same physical principles are involved in lock bumping, but the snap gun automates the transfer-of-energy process. A correctly applied snap gun can open a lock very quickly compared to traditional lock picking, but the sharp impact is more likely to damage the lock mechanism than raking, which mimics normal key movements.
An officer’s tool (also known as an A-tool, rex tool, or lock puller) is a forcible entry device used by firefighters and other first responders. Officer’s tools are designed to completely remove cylindrical locks from doors without causing major structural damage, allowing for direct access to the internal locking mechanism.
Three-point locking, or a multipoint lock, is a locking system installed in cabinet or locker doors to enable more secure locking. Whereas in single-point locking , the door on a cabinet locks only at the point where the key is turned, halfway up the edge of the door, three-point locking enables the top and bottom of the door to be ...