Search results
Results from the WOW.Com Content Network
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
Measuring the hatch in metric, you measure 25 mm. T he conversion factor for 1/4" to 3/16', according to the conversion table is .75. So 25 mm x .75 = 18.75 mm, or about 19 mm. That is the hatch size in 3/16" scale. Conversion is a fairly simple task once you start measuring in metric and converting according to the scale.
A small, electrically powered pump A large, electrically driven pump for waterworks near the Hengsteysee, Germany. A pump is a device that moves fluids (liquids or gases), or sometimes slurries, [1] by mechanical action, typically converted from electrical energy into hydraulic or pneumatic energy.
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
A PSH system stores energy in the form of gravitational potential energy of water, pumped from a lower elevation reservoir to a higher elevation. Low-cost surplus off-peak electric power is typically used to run the pumps. During periods of high electrical demand, the stored water is released through turbines to produce electric power.
As a result, the electric motors are normally mounted above the overflow, top water level of the wet well, usually above ground level, and drive the sewage pumps through an extended vertical shaft. To protect the above ground motors from weather, small pump houses are normally built, which also incorporate the electrical switchgear and control ...
The dominant European size for die-cast ship models, most comprehensive range. 1:1200: 0.01 0.254 mm: Ship models: A British and American size for ship and harbour models. Airfix used to produce in this scale. 1:1000: 0.305 mm This is a scale used in Germany for pre-finished airliner models. Herpa and Hogan Wings produces several models in this ...