Search results
Results from the WOW.Com Content Network
This switch is gang-operated so that all three phases are interrupted at the same time. Knife switches consist of a flat metal blade, hinged at one end, with an insulating handle for operation, and a fixed contact. When the switch is closed, current flows through the hinged pivot and blade and through the fixed contact.
Several manufacturers make switchboards used in industry, commercial buildings, telecommunication facilities, oil and gas plants, data centers, health care, and other buildings, and onboard large ships. A switchboard is divided into different interconnected sections, generally consisting of a main section and a distribution section.
The main distribution board in an installation will also normally provide a main switch (known as an incomer) which switches the phase and neutral lines for the whole supply. (n.b., an incomer may be referred to, or sold as, an isolator , but this is problematic, as it will not necessarily be used as an isolator in the strict sense.)
Interest in dead man's controls increased with the introduction of electric trams (streetcars in North America) and especially electrified rapid transit trains. The first widespread use came with the introduction of the mass-produced Birney One-Man Safety (tram) Car, though dead-man equipment was fairly rare on US streetcars until the successful PCC streetcar, which had a left-foot-operated ...
A switchgear may be a simple open-air isolator switch or it may be insulated by some other substance. An effective although more costly form of switchgear is the gas-insulated switchgear (GIS), where the conductors and contacts are insulated by pressurized sulfur hexafluoride gas (SF 6). Other common types are oil or vacuum insulated switchgear.
A network switch (also called switching hub, bridging hub, Ethernet switch, and, by the IEEE, MAC bridge [1]) is networking hardware that connects devices on a computer network by using packet switching to receive and forward data to the destination device.
A three-way switch is used to split a railroad track into three divergent paths rather than the more usual two. There are two types of three-way switches. In a symmetrical three-way switch, the left and right branches diverge at the same place. In an asymmetrical three-way switch, the branches diverge in a staggered way using two interlaced ...
The most widely used electronic switch in digital circuits is the metal–oxide–semiconductor field-effect transistor (MOSFET). [2] The analogue switch uses two MOSFET transistors in a transmission gate arrangement as a switch that works much like a relay, with some advantages and several limitations compared to an electromechanical relay.