Ad
related to: 2x4 on end vs flat side of metal post anchorebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The final tensioning operation undertaken during post-tensioning, resulting in the design prestress level being established within the member. [6]: 1 flat duct Ducting with an oval or "stadium" cross sectional shape. Such ducting is usually extruded (if plastic), or constructed from flat metal strip folded and joined with a longitudinal seam.
Story – A post only one story tall as in "storeyed construction" [12] also known as platform framing. Prick – 1) Same as story post, a one-story post for extra support at a particular location; 2) In a roof truss a side post. [13] Ridge – A post extending from the ground or foundation to the ridge beam.
Jack posts are telescopic tubular steel props consisting of two primary parts, the main part of the post, and the jack screw or other adjustable fitting on one or both ends. Both ends are normally fitted with flat metal plates on the end, providing additional support area.
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.
The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
This movement is known as the dynamic deflection. Given the lack of tension in the system, individual installations, or “runs”, of cable are limited to 2,000 ft (600 metres) with an anchor assembly at each end. Due to the low tension of the system, the cables tend to lie on the ground in the event that an impact damages multiple posts.
Ad
related to: 2x4 on end vs flat side of metal post anchorebay.com has been visited by 1M+ users in the past month