enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Pocket-hole joint being assembled. Pocket-hole joinery, or pocket-screw joinery, involves drilling a hole at an angle — usually 15 degrees — into one work piece, and then joining it to a second work piece with a self-tapping screw.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

5. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Instead, a one-way screw can be removed by drilling a hole through the head of the screw and inserting a screw extractor. Alternatively, a rotary tool with cutting disk can be used to extend the slot, the head can be gripped with locking pliers, or the screw can be removed with a pin spanner (snake-eyes driver) after drilling two holes in the ...

6. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

7. Confirmat screw - Wikipedia

   en.wikipedia.org/wiki/Confirmat_screw

   Confirmat screws on a sheet of the particleboard material in which they were designed to hold. Diagram of a hex-headed confirmat screw, made to be turned with an allen key A confirmat screw holding a butt joint in melamine-coated particleboard. A specialized stepped drill bit and a screw to match it. The screw is covered with a cosmetic plastic ...