Search results
Results from the WOW.Com Content Network
the fraction of the battery's capacity which is currently removed from the battery with regard to its (fully) charged state. For fully charged batteries, the depth of discharge is connected to the state of charge by the simple formula =. The depth of discharge then is the complement of state of charge: as one increases, the other decreases.
For example, consider a battery with a capacity of 200 Ah at the C 20 rate (C 20 means the 20-hour rate – i.e. the rate that will fully discharge the battery in 20 hours – which in this case is 10 A). If this battery is discharged at 10 A, it will last 20 hours, giving the rated capacity of 200 Ah.
Under certain conditions, some battery chemistries are at risk of thermal runaway, leading to cell rupture or combustion. As thermal runaway is determined not only by cell chemistry but also cell size, cell design and charge, only the worst-case values are reflected here.
Discharging the battery fully before recharging may be called "deep discharge"; partially discharging then recharging may be called "shallow discharge". A "charge cycle" is not a unit of time; the length of time spent charging or discharging does not affect the number of charge cycles. [1] Each battery is affected differently by charge cycles ...
The KiBaM battery model [3] describes the recovery effect for lead-acid batteries and is also a good approximation to the observed effects in Li-ion batteries. [1] [4] In some batteries, the gains from the recovery life can extend battery life by up to 45% by alternating discharging and inactive periods rather than constantly discharging. [5]
Their pouch cells have energy densities comparable to commercial Li-ion batteries (160 Wh/kg at cell-level), with good rate performance up to 3C, and cycle lives of 300 (100% depth of discharge) to over 1,000 cycles (80% depth of discharge). Its battery packs have demonstrated use for e-bike and e-scooter applications. [41]
The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery and the kind of service in which the battery is used. When testing the capacity of a NiMH or NiCd battery a cut-off voltage of 1.0 V per cell is normally used, whereas 0.9 V is normally used as the cut-off voltage of an alkaline cell ...
Nickel–zinc batteries have a charge–discharge curve similar to 1.2 V NiCd or NiMH cells, but with a higher 1.6 V nominal voltage. [5]Nickel–zinc batteries perform well in high-drain applications, and may have the potential to replace lead–acid batteries because of their higher energy-to-mass ratio and higher power-to-mass ratio – as little as 25% of the mass for the same power. [6]