Search results
Results from the WOW.Com Content Network
Soda siphons. As early as 1790, the concept of an "aerosol" was introduced in France, with self-pressurized carbonated beverages. [1] The modern siphon was created in 1829, when two Frenchmen patented a hollow corkscrew which could be inserted into a soda bottle and, by use of a valve, allowed a portion of the contents to be dispensed while maintaining the pressure on the inside of the bottle ...
BFS-packaged eye drops for single use. Blow-Fill-Seal, also spelled as Blow/Fill/Seal, in this article abbreviated as BFS, is an automated manufacturing process by which plastic containers, such as bottles or ampoules are, in a continuous operation, blow-formed, filled, and sealed.
It is commonly located near the restroom due to closer access to plumbing. A drain line is also provided from the water cooler into the sewer system. Water dispensers come in a variety of form factors, ranging from wall-mounted to bottle filler water dispenser combination units, to bi-level units and other formats.
Mariotte's bottle is a device that delivers a constant rate of flow from closed bottles or tanks. It is named after French physicist Edme Mariotte (1620-1684). A picture of a bottle with a gas inlet is shown in the works of Mariotte, [ 1 ] but this construction was made to show the effect of outside pressure on mercury level inside the bottle.
The term cylinder in this context is sometimes confused with tank, the latter being an open-top or vented container that stores liquids under gravity, though the term scuba tank is commonly used to refer to a compressed gas cylinder used for breathing gas supply to an underwater breathing apparatus.
A cascade filling system is a high-pressure gas cylinder storage system that is used for the refilling of smaller compressed gas cylinders. [ 1 ] [ 2 ] In some applications, each of the large cylinders is filled by a compressor , otherwise they may be filled remotely and replaced when the pressure is too low for effective transfer.
The bottle then enters a "filler" which fills the bottle with beer and may also inject a small amount of inert gas (usually carbon dioxide or nitrogen) on top of the beer to disperse the oxygen, as oxygen can ruin the quality of the product via oxidation. Finally, the bottles go through a "capper", which applies a bottle cap, sealing the bottle.
The bottle was designed to be interlocking, laid horizontally and bonded with cement mortar with a silicon additive. The necks were short and fitted into a large recess in the base, the bottles were square section with dimpled sides to bond with the mortar. A 10 ft (3.0 m) x 10 ft (3.0 m) shack would take approximately 1,000 bottles to build.