Search results
Results from the WOW.Com Content Network
A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
The early model C4 (1964–1969) used a .788-inch 24-spline input shaft, which was upgraded in 1970 to 26-spline and .839-inch. The upgrade also included a matching 26-spline clutch hub. In 1971, Ford went to a 26/24-spline input shaft, meaning the torque-converter side is 26-spline and the clutch hub is 24-spline.
The Ford C6 is a heavy-duty automatic transmission built by Ford Motor Company between 1966 and 2004. It was marketed as the "SelectShift Cruise-O-Matic." Compared to its predecessor MX transmission, the C6 offered lower weight, less complexity, less parasitic power loss, and greater torque capacity for larger engines.
The name 4R44E means 4 forward gears, rear-drive platform (or 4WD, with a different tailshaft housing), rated for 440 ft-lb torque (after torque converter multiplication) and electronic shifting. 4R55E is the same but heavier duty and rated for 550 ft·lbs.
The compact Comet shared a naming convention associated with the ongoing Space Race of the early 1960s with the Mercury Meteor, which was introduced as the base-trim full-size Mercury sedan. The Comet was initially based on the compact Ford Falcon, then on the intermediate Ford Fairlane, and finally on the compact Ford Maverick. Early Comets ...
Turbo-Hydramatic or Turbo Hydra-Matic is the registered tradename for a family of automatic transmissions developed and produced by General Motors.These transmissions mate a three-element turbine torque converter to a Simpson planetary geartrain, providing three forward speeds plus reverse.
The Vincent Comet was designed and built at the Vincent works in Great North Road, Stevenage, Hertfordshire, England.It was one of four 499 cc single models. As well as the sports Comet, Vincent produced a TT racing model, the Comet Special (a TT model with lights) and the standard Vincent Meteor which shared many of the same cycle parts.
This is an artist's concept of a comet dust trail and dust tail. The trail can only be seen in the light of radiated heat. The dust trail is made of particles that are the size of sand grains and pebbles. They are large enough that they are not affected much by the Sun's light and solar wind.