Search results
Results from the WOW.Com Content Network
A wedge socket termination is useful when the fitting needs to be replaced frequently. For example, if the end of a wire rope is in a high-wear region, the rope may be periodically trimmed, requiring the termination hardware to be removed and reapplied. An example of this is on the ends of the drag ropes on a dragline. The end loop of the wire ...
A block and tackle [1] [2] or only tackle [3] is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift heavy loads.. The pulleys are assembled to form blocks and then blocks are paired so that one is fixed and one moves with the load.
A wedge base holds the lamp by spring compression in the socket. The lamp is inserted and removed without twisting. Wedge base lamps are widely used in automotive applications, and many Christmas lights strings use plastic wedge-based bulbs. Other wedge bases include strip lamps, sometimes called architectural lamps, with S14s connections ...
A wedge base is a type of electrical connector used as a fitting for small light bulbs. It is similar to the bi-pin connector , except that the two "pins" are the same wires that extend into the bulb (rather than being rigid), and the wires are bent up onto the sides of the base, where they make contact with the socket.
Standard 12-point hex socket bits and wrenches fit these screws. The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water.
It is possible to use Socket 7 processors in a Socket 5. An adapter is required, or if one is careful, a socket 7 can be pulled off its pins and put onto a socket 5 board, allowing the use of socket 7 processors. Socket 8: 1995 Intel Pentium Pro: PGA: 387 ? 60–66 MHz Slot 1: 1997 Intel Pentium II Intel Pentium III: Desktop Slot: 242 ? 66 ...
The TNCA connector is a variant of the TNC connector specified in MIL-STD-348 [1] designed to provide an air gap in the dielectric region between the male and female connectors.
Two 44-pin edge connector sockets (blue objects) and matching circuit board. The Edge connector is 3.5 in (89 mm) long, with 22 contacts on each side Edge connector for PCIe x4. An edge connector is the portion of a printed circuit board (PCB) consisting of traces leading to the edge of the board that are intended to plug into a matching socket.