enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Polarity symbols - Wikipedia

   en.wikipedia.org/wiki/Polarity_symbols

   The symbol connected to the dot (usually the symbol found to the right) denotes the polarity of the center/tip, whereas the symbol connected to the broken circle denotes the polarity of the barrel/ring. When a device or adapter is described simply as having "positive polarity" or "negative polarity", this denotes the polarity of the center/tip.

3. Regulated power supply - Wikipedia

   en.wikipedia.org/wiki/Regulated_power_supply

   A regulated power supply is an embedded circuit; it converts unregulated AC (alternating current) into a constant DC. With the help of a rectifier it converts AC supply into DC. Its function is to supply a stable voltage (or less often current), to a circuit or device that must be operated within certain power supply limits.

4. Electronic symbol - Wikipedia

   en.wikipedia.org/wiki/Electronic_symbol

   Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...

5. Direct current - Wikipedia

   en.wikipedia.org/wiki/Direct_current

   In electronics, it is common to refer to a circuit that is powered by a DC voltage source such as a battery or the output of a DC power supply as a DC circuit even though what is meant is that the circuit is DC powered. In a DC circuit, a power source (e.g. a battery, capacitor, etc.) has a positive and negative terminal, and likewise, the load ...

6. Power supply - Wikipedia

   en.wikipedia.org/wiki/Power_supply

   An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics because of their safety; the hazardous 120 or 240 volt main current is transformed down to a ...

7. Single-line diagram - Wikipedia

   en.wikipedia.org/wiki/Single-line_diagram

   A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.

8. IC power-supply pin - Wikipedia

   en.wikipedia.org/wiki/IC_power-supply_pin

   IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.

9. H-bridge - Wikipedia

   en.wikipedia.org/wiki/H-bridge

   H bridge is used to supply power to a two terminal device. By proper arrangement of the switches, the polarity of the power to the device can be changed. Two examples are discussed below, DC motor Driver and transformer of switching regulator. Note that, not all of the case of switching condition is safe.