Search results
Results from the WOW.Com Content Network
Metamorphic rocks arise from the transformation of existing rock to new types of rock in a process called metamorphism. The original rock ( protolith ) is subjected to temperatures greater than 150 to 200 °C (300 to 400 °F) and, often, elevated pressure of 100 megapascals (1,000 bar ) or more, causing profound physical or chemical changes.
Metamorphic rocks with clockwise P-T-t paths are commonly associated with a near-isothermal decompressional P-T trajectory. [5] [6] Clockwise P-T-t path normally consists of three parts: [2] Initial heating and compression until arriving a peak, a high pressure-low temperature peak is often observed. (Prograde metamorphism until peak) [2]
Igneous rock, with gray groundmass and white phenocrysts marked. Orthoclase phenocrysts within a finer-grained matrix of a granite porphyry. The matrix or groundmass of a rock is the finer-grained mass of material in which larger grains, crystals, or clasts are embedded.
A conglomerate or any clastic sedimentary rock that consists of a single rock or mineral is known as either a monomict, monomictic, oligomict, or oligomictic conglomerate. If the conglomerate consists of two or more different types of rocks, minerals, or combination of both, it is known as either a polymict or polymictic conglomerate.
Lithic fragments can be derived from sedimentary, igneous or metamorphic rocks. A lithic fragment is defined using the Gazzi-Dickinson point-counting method and being in the sand-size fraction. Sand grains in sedimentary rocks that are fragments of larger rocks that are not identified using the Gazzi-Dickinson method are usually called rock ...
A metamorphic facies is a set of mineral assemblages in metamorphic rocks formed under similar pressures and temperatures. [1] The assemblage is typical of what is formed in conditions corresponding to an area on the two dimensional graph of temperature vs. pressure (See diagram in Figure 1). [ 1 ]
Cleavage is a type of rock foliation, a fabric element that describes the way planar features develop in a rock. Foliation is separated into two groups: primary and secondary. Primary deals with igneous and sedimentary rocks, while secondary deals with rocks that undergo metamorphism as a result of deformation. Cleavage is a type of secondary ...
Mylonite is a fine-grained, compact metamorphic rock produced by dynamic recrystallization of the constituent minerals resulting in a reduction of the grain size of the rock. Mylonites can have many different mineralogical compositions; it is a classification based on the textural appearance of the rock.