Search results
Results from the WOW.Com Content Network
A DC-to-DC converter is an electronic circuit or electromechanical device that converts a source of direct current (DC) from one voltage level to another. It is a type of electric power converter . Power levels range from very low (small batteries) to very high (high-voltage power transmission).
It acts as an electronic toggle switch, the half bridge is not able to switch polarity of the voltage applied to the load. The half bridge is used in some switched-mode power supplies that use synchronous rectifiers and in switching amplifiers. The half-H bridge type is commonly abbreviated to "Half-H" to distinguish it from full ("Full-H") H ...
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
A DC to DC converter circuit that uses capacitors to store energy between stages. charge transfer switch A kind of charge pump circuit. charge-coupled device An imaging sensor or data storage device that represents a signal, or pixel, by the charge stored in a capacitor and is able to move that charge from one capacitor to the next. Chebyshev ...
The full-bridge inverter is similar to the half bridge-inverter, but it has an additional leg to connect the neutral point to the load. [17] Figure 3 shows the circuit schematic of the single-phase voltage source full-bridge inverter.
Asymmetric bridge converter. The most common approach to powering an SRM is to use an asymmetric bridge converter. The switching frequency can be 10 times lower than for AC motors. [3] The phases in an asymmetric bridge converter correspond to the motor phases.
For example, the use of full-bridge configurations, common in MLCs, becomes optional, enabling the use of simpler half-bridge designs. This approach is primarily used as a Battery Management System (BMS), allowing variable DC sources to maintain many of the advantages of MLCs, such as improved battery utilization and better energy distribution.
Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency. However, the current supplied to the load is discontinuous and may ...