enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

3. Digital television adapter - Wikipedia

   en.wikipedia.org/wiki/Digital_television_adapter

   The input digital signal may be over-the-air terrestrial television signals received by a television antenna, or signals from a digital cable system. It normally does not refer to satellite TV , which has always required a set-top box either to operate the big satellite dish , or to be the integrated receiver/decoder (IRD) in the case of direct ...

4. Diplexer - Wikipedia

   en.wikipedia.org/wiki/Diplexer

   The dish antenna occupies the high frequencies (typically 950 to 1450 MHz), and the TV antenna uses lower television channel frequencies (typically 50 to 870 MHz). In addition, the satellite also gets a DC to low frequency band to power the dish's block converter and select the dish antenna polarization (e.g., voltage signaling or DiSEqC ).

5. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

6. SMATV - Wikipedia

   en.wikipedia.org/wiki/SMATV

   The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used.

7. Power dividers and directional couplers - Wikipedia

   en.wikipedia.org/wiki/Power_dividers_and...

   In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21. Splitter and combiner networks used with amplifiers to produce a high power 40 dB (voltage gain 100) solid state amplifier Figure 22. Phase arrangement on a hybrid power combiner.