Search results
Results from the WOW.Com Content Network
The tightening screw's worm thread engages with the slots on the clamp band. Occasionally a worm drive is designed to run in reverse, resulting in the worm shaft turning much faster than the input. Examples of this may be seen in some hand-cranked centrifuges, blacksmithing forge blower, or the wind governor in a musical box.
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
Most screw threads are oriented so that when seen from above, the screw shaft moves away from the viewer (the screw is tightened) when turned in a clockwise direction. [ 21 ] [ 22 ] This is known as a right-handed ( RH ) thread, because it follows the right hand grip rule : when the fingers of the right hand are curled around the shaft in the ...
A knuckle joint on a locomotive, seen behind the pin joint of the eccentric crank. Ball-point pen included for size. A mechanical joint is a section of a machine which is used to connect one or more mechanical parts to another. Mechanical joints may be temporary or permanent; most types are designed to be disassembled.
Offset: If the line of travel of the hinged joint of the slider does not pass through the base pivot of the crank, the slider movement is not symmetric. It moves faster in one direction than the other. This is called a quick-return mechanism. There are also two methods to design each type: graphical and analytical.
For premium support please call: 800-290-4726 more ways to reach us
A coupler connecting a crank and a slider in a single slider crank mechanism is often called a connecting rod, however, it has also been used to refer to any type of coupler. There are three basic types of planar four-bar linkage, depending on the use of revolute or prismatic joints:
A screw thread, often shortened to thread, is a helical structure used to convert between rotational and linear movement or force. A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread.