Search results
Results from the WOW.Com Content Network
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
It allows a V6 or V8 engine to "turn off" half of the cylinders under light-load conditions to improve fuel economy. Estimated performance on EPA tests shows a 5.5–7.5% improvement in fuel economy. [1] GM's Active Fuel Management [2] technology used a solenoid to deactivate the lifters on selected cylinders of a pushrod V-layout engine.
It simultaneously couples the standard direct injection system found on Gen 5 engines with port fuel injection, specifically to satisfy upper-RPM fuel demands. Power output is 755 hp (765 PS; 563 kW) at 6400 rpm and 715 lb⋅ft (969 N⋅m) of torque at 3600 rpm.
The term fuel injection is vague and comprises various distinct systems with fundamentally different functional principles. The only thing all fuel injection systems have in common is the absence of carburetion. There are two main functional principles of mixture formation systems for internal combustion engines: internal and external.
Second big problem: GM's cost-cutters decided not to fit a water separator. Unlike gasoline, diesel fuel is subject to water condensation – hence the need for a water separator. Without one, water in the fuel becomes water in the engine, where it can rust either the cylinders or the complicated mechanical fuel injection pump.
The GM High Feature engine (also known as the HFV6, and including the 3600 LY7 and derivative LP1) is a family of modern DOHC V6 engines produced by General Motors. The series was introduced in 2004 with the Cadillac CTS and the Holden Commodore (VZ). It is a 60° 24-valve design with aluminum block and heads and sequential multi-port fuel ...
The non-lifting Nathan 4000 injector used on the Southern Pacific 4294 could push 12,000 US gallons (45,000 L) per hour at 250 psi (17 bar). [11] The lifting injector can operate with negative inlet fluid pressure i.e. fluid lying below the level of the injector. It differs from the non-lifting type mainly in the relative dimensions of the nozzles.
Gasoline direct injection (GDI), also known as petrol direct injection (PDI), [1] is a mixture formation system for internal combustion engines that run on gasoline (petrol), where fuel is injected into the combustion chamber. This is distinct from manifold injection systems, which inject fuel into the intake manifold (inlet manifold).