Search results
Results from the WOW.Com Content Network
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [1] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
At a minimum, if the CPU, BIOS, and the I/O interface upon which the POST card relies on are all working, a POST card can be used to monitor the system's Power-On Self Test (POST), or to diagnose problems with it.
The BIOS in older PCs initializes and tests the system hardware components (power-on self-test or POST for short), and loads a boot loader from a mass storage device which then initializes a kernel. In the era of DOS , the BIOS provided BIOS interrupt calls for the keyboard, display, storage, and other input/output (I/O) devices that ...
S.M.A.R.T. drives may offer a number of self-tests: [104] [105] [106] Short Checks the electrical and mechanical performance as well as the read performance of the disk. Electrical tests might include a test of buffer RAM, a read/write circuitry test, or a test of the read/write head elements. Mechanical test includes seeking and servo on data ...
FPGAs, and PLAs allow POST (and BIOS) to exist as hardware. Before either one existed state machines existed in hardware. Most implemented a power-on self test -- imagine trying to debug one of these things without knowing if the machine was able to provide reliable debug information. Kernel.package 23:37, 30 September 2010 (UTC)
The main advantage of LBIST is the ability to test internal circuits having no direct connections to external pins, and thus unreachable by external automated test equipment. Another advantage is the ability to trigger the LBIST of an integrated circuit while running a built-in self test or power-on self test of the finished product.
This program runs a power-on self-test (POST) to check and initialize required devices such as main memory , the PCI bus and the PCI devices (including running embedded Option ROMs). One of the most involved steps is setting up DRAM over SPD, further complicated by the fact that at this point memory is very limited.
When the card is installed, the LED remains lit for two to five seconds as a self-test runs. If the self-test completes successfully, the LED flashes three times and remains lit until the card is configured and enabled in software, then the LED goes out. If the LED continually flashes or remains weakly lit, there is a fault detected in the card.