Search results
Results from the WOW.Com Content Network
The gusset plate is usually painted to match nearby steel and fixtures and to give it an extra layer of protection. [2] Occasionally gusset plates are made from copper or aluminum, but only with small structures that do not require much support. The copper and aluminum gusset plates also provide a more attractive finish for exposed structures. [2]
An SPW frame can be idealized as a vertical cantilever plate girder, in which the steel plates act as the web, the columns act as the flanges and the cross beams represent the transverse stiffeners. The theory that governs plate design should not be used in the design of SPW structures since the relatively high bending strength and stiffness of ...
Most trusses use gusset plates to connect intersecting elements. Gusset plates are relatively flexible and unable to transfer bending moments. The connection is usually arranged so that the lines of force in the members are coincident at the joint thus allowing the truss members to act in pure tension or compression.
Finally, the stiffeners increase the resistance of the plate to buckling. The same structural effects are also true of the concrete slab in a composite girder bridge, but the steel orthotropic deck is considerably lighter, and therefore allows longer span bridges to be more efficiently designed.
The stiffeners are usually considered pinned end. Power plant ductwork can be 5/16" thick duct plate, with "fixed end" W stiffeners at roughly 2'-5" spacing. Because rectangular duct plate bends, stiffeners are required at reasonably close spacing. Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided.
Gusset plates, usually triangular, are often used to join metal plates and can be seen in many metal framed constructions. Expanding folders or accordion folders also employ gussets to allow for expansion when containing more than just a few sheets of paper. The gusset is also a charge in heraldry, as is the gyron (an Old French word for gusset).
When the door is closed, the bolt extends into the hole in the strike plate and holds the door closed. The strike plate protects the jamb against friction from the bolt and increases security in the case of a jamb made of a softer material (such as wood) than the strike plate. Some strike plates have their hole size and placement calculated so ...
Thicknesses can vary significantly; extremely thin sheets are considered foil or leaf, and pieces thicker than 6 mm (0.25 in) are considered plate, such as plate steel, a class of structural steel. Sheet metal is available in flat pieces or coiled strips. The coils are formed by running a continuous sheet of metal through a roll slitter.