Search results
Results from the WOW.Com Content Network
A number of ground-level power supply systems were developed from the 1970s through the 1990s, [8] but were not reliable or safe enough for commercial use. [9] The first ground-level power supply system developed to modern safety standards was the Ansaldo Stream, [7] although a competing system, Alstom APS, was the first to be commercially ...
A wiring diagram for parts of an electric guitar, showing semi-pictorial representation of devices arranged in roughly the same locations they would have in the guitar. An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing.
The automobile self starter was an early engine system to use this. Lighting, which had previously been provided by kerosene lamps or gas lamps, was one of the first common electrical accessories. Early systems used 6 volts, but 12 volts became the standard because it provided greater power with less current.
The voltage of the power outlet is usually near 12 V DC, and may be elevated between 13.5 V to 15 V while the engine is running. On trucks, the voltage of the power outlet may be near 24 V DC. The 12 V power circuit is protected by a car fuse, often rated at 10 to 20 amperes, which provides 120 to 240 watts of power. Large appliances such as ...
A typical 12 V, 40 Ah lead-acid car battery. An automotive battery, or car battery, is a rechargeable battery that is used to start a motor vehicle.. Its main purpose is to provide an electric current to the electric-powered starting motor, which in turn starts the chemically-powered internal combustion engine that actually propels the vehicle.
High-power devices should be placed closest to the power supply, while low-power devices can be placed farther from it. Signals, wherever possible, should be differential . Isolated power supplies require careful consideration of parasitic, component, or internal PCB power plane capacitance that can allow AC present on input power or connectors ...
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.