Ads
related to: fddi vs ethernet adapterwalmart.com has been visited by 1M+ users in the past month
ebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
FDDI provides a 100 Mbit/s optical standard for data transmission in local area network that can extend in length up to 200 kilometers (120 mi). [2] Although FDDI logical topology is a ring-based token network, it did not use the IEEE 802.5 Token Ring protocol as its basis; instead, its protocol was derived from the IEEE 802.4 token bus timed token protocol.
Token Ring and legacy Ethernet have some notable differences: Token Ring access is more deterministic, compared to Ethernet's contention-based CSMA/CD. Ethernet supports a direct cable connection between two network interface cards by the use of a crossover cable or through auto-sensing if supported. Token Ring does not inherently support this ...
Many Ethernet adapters and switch ports support multiple speeds by using autonegotiation to set the speed and duplex for the best values supported by both connected devices. If autonegotiation fails, some multiple-speed devices sense the speed used by their partner, [ 1 ] but this may result in a duplex mismatch .
A network interface controller (NIC, also known as a network interface card, [3] network adapter, LAN adapter and physical network interface [4]) is a computer hardware component that connects a computer to a computer network. [5] Early network interface controllers were commonly implemented on expansion cards that plugged into a computer bus.
These responsibilities encompass bit timing, signal encoding, interacting with the physical medium, and the properties of the cable, optical fiber, or wire itself. Common examples are specifications for Fast Ethernet, Gigabit Ethernet and 10 Gigabit Ethernet defined by the Institute of Electrical and Electronics Engineers (IEEE).
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
Ads
related to: fddi vs ethernet adapterwalmart.com has been visited by 1M+ users in the past month
ebay.com has been visited by 1M+ users in the past month